O and G Scale Crossbuck Controller The O and G Scale Crossbuck Controller circuit is designed to automatically turn on and off a pair of crossbucks for a crossing. The crossbuck controller has a pair of sensors that can be mounted underneath the track to monitor for trains. When a train crosses over the sensor the crossbucks flash. The crossbucks will continue to flash until the train uncovers both sensors. This controller will work with any crossbucks that run on AC accessory terminals from your power pack(14-24v AC). Note this is designed to work with the 3 wire per crossbuck signal, 2 red and one black. Because the TMI Crossbuck Controller circuit measures approximately 2.5 inches by 3.5 inches it is small enough to be mounted under any building or under the layout.

The TMI Crossbuck Controller circuit is designed to run off standard 14 to 24V AC accessory terminals from your power pack. The TMI Crossbuck Controller is a complete circuit board, soldering is required only to extend the length of the sensors.

We have seen similar products for as much as $119 elsewhere. Our Crossbuck Controller is $29.95 plus shipping and handling. NOTE: This circuit does not include the crossing signals, car, buildings or figure.